Slurry Pump Parts

Pump Parts Introduction：
Our pumps’ strength lies in the advanced hydraulic design and the high standard of casting
technology, high performance of wear life, which helps clients reduce the cost and easy operation.
The wearing parts include impeller, volute liner, throat bush, FPL insert, shaft sleeve, seals, etc.
These parts are very easily worn-out parts because they work under longtime impact of abrasive
and corrosive slurries in the high speed. So we strongly recommend clients should prepare
enough wearing parts in their stock in case of emergent repair or maintenance, making sure
the continuous steady running.
There are mainly two wet parts material:
M: metal (wear-resistant ultra chrome alloy)
R: rubber (R26; R33; R55; R08; S31;S42 ...)

 
Slurry Pump Main parts:
• Impeller - front and rear shrouds have pump out vanes that reduce recirculation and seal contamination.
  Hard metal and molded rubber impellers are complete interchangeable. Cast in impeller threads require
  no inserts or nuts. High efficiency and high head designs are also available.
• Liners - Easily replaceable liners are bolted, not glued, to the casing for positive attachment and ease of
  maintenance. Hard metal liners are completely interchangeable with pressure molded elastomers.
  Elastomer seal rings back all liner joints.
• Throat Bush - Wear is reduced and maintenance simplified by the use of tapered mating faces to allow
  positive accurate alignment during assembly and simple removal.
• Bearing assembly - A large diameter shaft with short overhang minimizes deflection and contributes to
  long bearing life. Only four through bolts are required to hold the cartridge type housing in the frame.